Tree Irrigator Bag

The Tree Irrigator bag simply zips around the tree trunk and allows you to fill up the bag with water. For trees with a wider girth diameter (10cm plus) use a double bag set up – two bags zipped together.

It is perfect for newly planted or established trees which are up to 20cm in diameter. Branches should start at minimum of 64cm from the ground.

A single Tree Irrigator bag holds approximately 75 litres of water which is gradually released over 2 to 6 hours.(Depending on soil type and conditions)

TREE IRRIGATOR WATERING BAG SPECIFICATION:

• Single bag fits trees with a diameter of 3cm to 8cm and branches a minimum of 64cm from the ground
• Use a Double Bag setup (two single bags zipped together back-to-back) to water trees with a diameter of 10cm to 20cm
• Made of green polyethylene with scrim reinforcement, black polypro straps and nylon zippers
• Two water release points per bag
• Bag is empty in approximately 2 to 6 hours.(Depending on soil type and conditions)
• UV stabilized to withstand exposure to sunlight.
• Fill opening fits up to 8cm diameter hose
• Measurements: Full – 76cm tall x 46cm wide (at base)

• The Tree Irrigator provides simple, affordable patented tree watering technology:
• Saves time, water, effort and trees
• Ideal for newly planted trees in shaded or urban environments
• Can be installed after a tree has been planted – no need for an underground irrigation system
• Reduces transplant and drought shock
• 100% water absorption with no run-off
• Fill just 1 to 2 times per week, or as needed
• Install and fill in minutes with no tools required
• Deep water saturation with every fill
• Promotes deep root growth
• Non-invasive design will not harm existing landscape
• Can be removed and reused
• Can be used with nutrient/chemical additives
• Zip multiple bags together to accommodate large trees

WATERING CAPACITY/FREQUENCY CHART