Green-tech
Clock Icon MON - FRI 08:00 - 17:00
Phone Icon Call Us
Basket 0 Items | £0.00

Order Summary

There are no items in your basket
Delivery Icon Nationwide Delivery
Padlock Icon Secure Online Payments
Explosion Icon Established Over 20 Years
Iso Icon ISO 9001 & 14001 Accredited
Quote My ProjectGo to page Pay Invoice OnlineGo to page
  1. Home
  2. Products
  3. Pond Liner & Lake Liner
  4. Pond Accessories
  5. Pond Repair Strip 1mm x 150mm x 1m

Pond Repair Strip 1mm x 150mm x 1m

Product Code: 200MP2108-PRO
In Stock

The self-adhesive 1mm thick EPDM rubber 150mm wide strip incorporating a polyester textile scrim and a 0.6mm sticky Butyl based adhesive backing. This self adhesive strip can be used to repair small holes in both Butyl and EPDM liners.

Full Description Installation Guide Remove From My Favourites Add to My Favourites
Quantity
- +
Price
£29.40
£24.50 Ex VAT
Add to Basket Buy

This self adhesive strip can be used to repair small holes in both Butyl and EPDM liners. A rubber pond repair strip to repair small holes in both Butyl and EPDM liners. A self-adhesive 1mm thick EPDM rubber 150mm wide strip incorporating a polyester textile scrim and 0.6mm sticky Butyl based adhesive backing. This one sided self-adhesive strip can be used to repair small holes in liners.

To prevent uplift of the patch a bead of sealant can be applied around the patch circumference.

The Strip is sold Per metre.

Instructions for use: 1. Ensure the damaged membrane is free from any jagged edges that are likely to continue tearing if any stress is applied. This is achieved by rounding off likely edges/tears with a sharp pair of scissors. 2. Clean the membrane around the damaged area and at least 200mm beyond with a scouring pad and clean water (for an older liner- with a wire brush to reveal fresh membrane). 3. Ensure the cleaned area is completely dry, by carefully heating the membrane with a hot air gun. 4. Prepare a repair patch making sure that the patch overlaps the damaged area by a minimum of 100mm on all sides. Also ensure that the corners of the patch are rounded to prevent uplift when applied. 5. Position the prepared patch centrally over the damaged area, then working from the centre outwards apply the patch to the membrane and using a suitable 40/50mm roller and roll flat with an outward motion until the entire patch has been applied. 6. To prevent uplift of the patch edge apply a 1cm bead of sealant to the entire edge of the patch ensuring the bead overlaps the membrane and patch equally and to a depth of 4mm. This will protect the tacky exposed repair edge from contamination and uplift and provide a secondary seal between the membrane and repair patch. Leave for a minimum of one hour for the repair to harden before submersing in water.